11-24-2017, 10:46 AM
Good morning All,
I will be the first to admit, that when I saw the Automatic Outline tool in KC 4.4 I couldn't think of any actual benefit to me or any projects I've worked on.
I was wrong, very wrong! Having watched the YouTube tutorial, https://www.youtube.com/watch?v=HiTVcWfJI3E it became obvious that this was an invaluable tool.
Having just completed a project, this morning, using the tool i'd like to make the following comments for other users.
Firstly, in the existing GL screen, you must add your contours and/or points before using the outline tool, after that its done, brilliant!
Thank you to the team at Kubla Cubed for making cut and fill a pleasure instead of a chore.
P.S. If you would like to produce something to speed up drainage take-off, i'm all ears - only joking
Cheers
Tim
I will be the first to admit, that when I saw the Automatic Outline tool in KC 4.4 I couldn't think of any actual benefit to me or any projects I've worked on.
I was wrong, very wrong! Having watched the YouTube tutorial, https://www.youtube.com/watch?v=HiTVcWfJI3E it became obvious that this was an invaluable tool.
Having just completed a project, this morning, using the tool i'd like to make the following comments for other users.
Firstly, in the existing GL screen, you must add your contours and/or points before using the outline tool, after that its done, brilliant!
Thank you to the team at Kubla Cubed for making cut and fill a pleasure instead of a chore.
P.S. If you would like to produce something to speed up drainage take-off, i'm all ears - only joking
Cheers
Tim