(05-10-2020, 10:30 PM)h-earthworks Wrote: Is there a way to layout a square or define the angle of a corner point for platforms and slopes? My job is a 6 acre sloping pad. The only info to go on is end and side lengths with instructions to have pad square with the property line. Hard to draw exact edge lengths and get perfect rectangle by just drawing on the screen. Sure its a simple solution that im missing. Wes
Also in addition to Rich's answer you can actually use the snap to grid but instead of using the origin of 0,0 you can set your own origin point. To do this make sure you have the latest version V5.11 or higher.
Edit->Snap Points->Grid Interval Origin
Basically you can either type in an origin point or go into the designer and set it by pressing Ctrl+O.
