Welcome Guest, Not a member yet? Create Account  

Kubla Central Kubla Cubed Feedback & Suggestions Batter Spilling on Structures

Batter Spilling on Structures

  • Offline GWeldt
    Junior Member
  • **

  • Posts: 3
    Threads: 3
    Joined: Jun 2022
    Reputation: 0
#1
7 hours ago (This post was last modified: 7 hours ago by GWeldt. Edit Reason: Images did not display properly )

Hi, I have recently noticed that side batters modelled on Kubla don't really function properly in scenarios where 'Fill' is being placed against a near vertical surface (say bridge abutment). 
Currently, the fill batters project through the vertical surface where any spill is identified. 
Ideally, the spill batters should slope down along the rear of the wall at the same defined slope rate.  
See attached model with the intended slope manually modelled using the feature surface tool.

Attached Files
.kcp   Kubla - Spill Batter Issue.kcp (Size: 11.38 KB / Downloads: 2)
Reply


Messages In This Thread
Batter Spilling on Structures - by GWeldt - 7 hours ago



Users browsing this thread:
1 Guest(s)